First you should check, whether and which IPv6 addresses are already configured (perhaps auto-magically during stateless auto-configuration).
Just note that addresses beginning with ”fec0” are deprecated, but shown here for completness!
Usage:
# /sbin/ip -6 addr show dev <interface>
Example for a static configured host:
# /sbin/ip -6 addr show dev eth0 2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_ fast qlen 100 inet6 fe80::210:a4ff:fee3:9566/10 scope link inet6 2001:0db8:0:f101::1/64 scope global inet6 fec0:0:0:f101::1/64 scope site
Example for a host which is auto-configured
Here you see some auto-magically configured IPv6 addresses and their lifetime.
# /sbin/ip -6 addr show dev eth0 3: eth0: <BROADCAST,MULTICAST,PROMISC,UP> mtu 1500 qdisc pfifo_fast qlen ¬ 100 inet6 2002:d950:f5f8:f101:2e0:18ff:fe90:9205/64 scope global dynamic valid_lft 16sec preferred_lft 6sec inet6 3ffe:400:100:f101:2e0:18ff:fe90:9205/64 scope global dynamic valid_lft 2591997sec preferred_lft 604797sec inet6 fe80::2e0:18ff:fe90:9205/10 ¬ scope link
Usage:
# /sbin/ifconfig <interface>
Example (output filtered with grep to display only IPv6 addresses). Here you see different IPv6 addresses with different scopes.
# /sbin/ifconfig eth0 |grep "inet6 addr:" inet6 addr: fe80::210:a4ff:fee3:9566/10 Scope:Link inet6 addr: 2001:0db8:0:f101::1/64 Scope:Global inet6 addr: fec0:0:0:f101::1/64 Scope:Site